← All tools

HERTZKIT / VOCALS & INSTRUMENTAL

Separate vocals and instrumental

Create a vocal track and an instrumental from your recording. Practice singing, study an arrangement or work on your own music. Your audio stays on your device.

MP3 or WAV · up to 10 minutes and 128 MB · processing on your device

Your access

Checking your session…

Sign in with your free account, verified email and completed profile. If you are already signed in to HertzKit, the same session applies. Audio is not uploaded for separation.

Usage and retries

You can start another separation after finishing or cancelling the current one, without a fixed wait between files. Free access allows up to 12 starts per hour per account, including retries. One separation runs at a time in this tab. File limits and abuse protection still apply.

Access rules and privacy

1. Prepare your audio

Have a PCM WAV over the limit? Load just a section in the Trimmer.

Load a recording to begin

Then listen and choose the full audio or a fragment of at least one second.

The entire file must meet both limits: 10 minutes and 128 MB. Choosing a fragment does not allow a larger file.

2. Follow the process

When you press Separate, access is checked and required files are prepared. The first run can take longer.

If you need to cancel

You can request cancellation at any time. It may take time to complete because the current part of the audio must finish processing. Keep this page open until the status confirms it has stopped.

On a phone, start with a short fragment. Keep this page open until processing finishes; speed depends on your device.

3. Compare and download

When separation finishes, the vocals and instrumental will appear alongside the original reference. You can listen and download each WAV.

How to use the separator

  1. Sign in with your free account and load a recording you own or are authorized to use.
  2. Listen to the reference. Use the full audio or enable Choose a fragment to set boundaries on the waveform or with the numbers.
  3. Confirm your authorization to use the audio and press Separate. A short test also counts as an authorized start.
  4. Compare both outputs with the reference and download the WAV files before leaving. They are not saved automatically.
Files and progress

The complete file must meet the limits: 10 minutes and 128 MB per file, mono or stereo. Both limits apply. A compressed file expands in memory when decoded; available memory and format support depend on the device and browser. Short excerpts usually finish sooner.

The progress panel identifies the current stage. During separation, the remaining time is an estimate based on your device’s progress; downloading and preparation are shown separately. Reading and measurable calculations show a percentage; decoding or stages without measurable progress show a waiting indicator. A completed stage is followed by the next stage. “Download requested” means the browser received a ready file: check its downloads list and open the result. This page cannot confirm that it was saved to disk.

Prepare a track for analysis: a practical guide →

Requirements and expected speed

A computer with available memory is recommended. CPU and GPU can produce different processing times; speed is not guaranteed. In a local four-thread CPU test, five minutes of audio took about ten minutes to separate and the browser used around 2 GB of memory. Your device may be faster or slower. Phones and low-memory devices may fail. A short section used to check the result counts as one start within the hourly limit.

The first use needs to download additional files and may take longer. Your browser tries to save them to speed up later uses. Your audio is processed on your device.

Tool provenance and licenses

Frequently asked questions

Is my audio sent to a server for separation?

No. Separation runs on your device. Verified email and access authorizations are managed by the separator service. This does not mean all site browsing is anonymous.

Which files does it accept and export?

Mono or stereo MP3 or WAV, up to 10 minutes and 128 MB per file; both limits apply. It exports vocals and instrumental as 24-bit WAV. It does not produce separate tracks for every instrument or guarantee clean vocals. Speed and memory requirements depend on your device.