Generate & process audio
Tone generator
Choose a frequency, listen to the reference and explore its waveform. Prepare a tone or sweep as WAV at the file level you need.
1 · Choose a frequency
StoppedReady to play.
Waveform and spectrum
Waveform and spectrum · relative, uncalibrated scales.
2 · Set the sound
Frequency sweep
Sweeps from 20 Hz to 20 kHz with the selected waveform, then stops. It does not measure hearing or your equipment response.
Start at a low volume. Do not turn it up to try to hear extreme frequencies.
3 · Create a WAV file
Set the file level in dBFS, independently of the listening level. The tone uses the selected frequency and waveform; exported sweeps always use a sine wave.
The file is generated in your browser and is not uploaded anywhere. On a phone, the download depends on your browser.
How to use the generator
- Choose a frequency from 20 Hz to 20 kHz using the number, slider or a reference. The note display uses A4 = 440 Hz. Nothing plays on page load. On mobile, open Waveform and spectrum to view the signal.
- Keep your device volume low, choose a waveform and press Play. HertzKit starts at 20%. Balance moves playback left or right; Centre returns it to the middle.
- The tone stops after 10 seconds by default. Choose another time or No timer if needed; changing it during a tone starts a new countdown. A sweep has its own duration and stops when complete. Changing frequency during a sweep switches to a fixed tone with the selected timer.
- To create a file, open Create a WAV file. Set tone or sweep, duration, file level in dBFS, channels, sample rate and bit depth. Press Prepare WAV, then Download WAV. If you change signal or file settings, prepare it again. Output is stereo, even when only one channel contains signal. Stop a playing sweep before preparing a fixed tone.
Playback and file
File level is independent of listening level. A 0 dBFS WAV may play loudly: check the destination volume. Exported sweeps always use sine, even if playback uses another waveform. Dither applies only at 16 bits; a channel configured as silent keeps digital silence. Sharing copies frequency, waveform and balance, never volume. Leaving the page stops sound. Switching tabs may keep it playing; device locking, a call or browser policy may interrupt it. If that happens, press Play to start it again. Files are prepared on your device.
Frequently asked questions
Can I calibrate a speaker with this generator alone?
No. It produces a signal; calibration requires an appropriate microphone, measurements and a reference procedure. Audibility depends on the speaker, environment and your hearing.
Do all waveforms sound equally loud at the same level?
Not necessarily. Spectrum and energy change with waveform. Adjust listening carefully rather than raising volume to hear extremes your equipment cannot reproduce.