On this page8 sections

In the idea recorder, prepare the input, record, then listen and keep the take. Open Input level if you need to check the meters or adjust gain. Finish releases the microphone. Download saves a file to your device; Save in this browser keeps a local copy that does not sync to your account.

Before opening the recorder

Listen to the room in silence. A computer, window or fan may be audible in the recording even after you stop noticing it. Try another location before buying equipment. A furnished room is usually a more useful starting point than an empty corner. Choose a position, sing a phrase and listen back: let the recording guide you.

Distance and level

As an initial experiment, place the microphone about 15–20 cm away and use a pop filter if available. That distance is not right for every microphone or voice. Move slightly and compare body, consonants and room sound. Set gain while singing the loudest part; leave headroom below 0 dBFS and avoid clipping indicators. Raising volume later is preferable to recording clipped audio.

Adjust the microphone level

The “Microphone level in HertzKit” control adjusts the signal inside the page: 100% preserves incoming amplitude, 75% reduces it, and 50% is approximately −6 dB. Mute with 0% or increase up to 200% (+6 dB). Start at 100%, test the loudest passage and leave headroom below 0 dBFS.

The first meter shows the signal received from the device; the second shows the adjusted signal. If the first reaches full scale or you hear source distortion, lower the system or interface gain; reducing the web control cannot repair already clipped audio. Increasing gain also increases noise: it does not make a noisy signal more accurate. The setting affects subsequent recording or analysis, not uploaded files or earlier takes. It lasts only while this page remains open.

A thirty-second test

Choose the input and check its meter before recording. Follow this short sequence:

  1. 0–10 sQuiet phrase

    Sing a short phrase at a comfortable level.

  2. 10–20 sLoudest passage

    Try the loudest part you intend to record; do not force your voice.

  3. 20–30 sRoom sound

    Stay in position without singing or touching the microphone.

Suggested timings, not an automatic timer. Listen to all three parts before changing the distance or gain.

Listen on headphones for plosives, obvious reflections, dropouts or distortion. Change one thing and repeat. Idea recorder is intended for sketches; format and continuity depend on the browser. You can pause and resume within the same take; Finish closes capture and releases the microphone. The waveform and playback controls are for review, not trimming. Playback volume does not change the file. Keep the page active. For an important session, use a DAW or dedicated recorder and verify that the take was saved.

Keep the takes worth keeping

Name the take and press Save in this browser. Nothing is saved automatically: the local limit is 10 takes and 128 MiB in total. My account does not back up these recordings. Download important takes and open the file before deleting a take or closing the page. Browser data can be cleared, and the library does not transfer itself to another device.

A saved take can be opened for playback, downloaded or deleted. Changing and saving its name updates the same take without creating another copy. Remove take only closes the workspace take. In Download format you can choose Original, WAV or MP3. WAV creates a 24-bit PCM copy and MP3 a 192 kbps copy, both at 48 kHz. Playback and local saving still use the original. Conversion does not recover lost quality; MP3 may add a little padding.

Put the idea into practice

Open Idea recorder →

Reference for further reading

Shure: how to record and mix vocals.

Vocal pitch practice

For singing notes, intervals and scales, try the vocal trainer. It shows a continuous curve and lets you listen to and compare two attempts without grading your technique.

Open vocal trainer · Vocal pitch guide