← All tools

Record and review audio

Musical idea recorder

Record a melody, lyrics or a practice session. Pause when needed, listen back, then download the take or save it in this browser.

1 · Prepare the input

Allow microphone access to see input names.

Input level · optional

Input level

100% · 0 dB
—
—

How to set the level

Test the loudest passage and leave headroom below 0 dBFS. 100% keeps the amplitude; 50% is −6 dB and 200% is +6 dB. This trim acts inside HertzKit: it does not change hardware gain or repair an already distorted input. If the device clips, lower system or interface gain. Meters are approximate. This setting is not kept after closing the tab.

The microphone is not played through speakers. Finishing a take releases the input.

2 · Record your idea

Microphone off0:00.0

Up to ten minutes of audio. Paused time is not added to the take.

Activate the microphone to check your input, or press Record to start.

3 · Listen and keep the take

Your take appears here when recording finishes.

0:00.0 / 0:00.0

Original keeps the recorded file. WAV is useful for editing; MP3 makes a smaller copy for sharing. Conversion does not recover quality lost during recording. Playback and local saving use the original take.

Takes saved in this browser

Saving is optional: up to ten takes and 128 MiB total, only in this browser. Takes do not sync to your account or other devices. Download important takes: clearing site data or browser cleanup may delete these takes.

    How to record and keep an idea

    1. Choose a microphone and press Activate microphone. Speak or play the loudest passage, check the meters and set the level. Nothing is recorded yet. You can also press Record directly; permission is requested if needed.
    2. Press Record. Pause stops adding audio to the take and Resume continues it; the microphone stays active while paused. Finish closes the take and releases the microphone. The maximum is ten minutes of audio; ten minutes paused also finishes capture.
    3. Listen with Play, Pause, Stop and Loop. The waveform and slider move playback; they do not trim the take. Playback volume does not change the download.
    4. Name the take and download the audio, or optionally save it in this browser. Saving a changed name does not duplicate the take. Under Saved takes you can open it for playback, download it or delete it. Remove take only closes the workspace copy and keeps saved takes.

    In Download format, Original keeps the browser file, such as WebM/Opus, M4A or Ogg/Opus. WAV creates 24-bit PCM and MP3 a 192 kbps copy, both at 48 kHz with the take’s channel count. Wait for conversion before downloading. You can cancel and return to the original. Changing format pauses playback. Save in this browser always keeps the original take without duplicating it.

    Keep the page open and download before leaving. Calls, locking your phone or switching apps may interrupt capture depending on your browser and system. If input is lost, received audio is preserved where possible for you to review. The current take is not saved automatically.

    Prepare a vocal recording · WAV and MP3 converter

    Frequently asked questions

    Does it record directly to WAV or MP3?

    Recording uses the format supported by your browser. You can then choose Original, WAV or MP3 for download. WAV and MP3 are converted on your device; they do not recover quality lost during capture. The original is kept. MP3 may add a few milliseconds of padding at the start or end.

    Is it kept after closing the page?

    The current take stays in memory and is not saved automatically. Save in this browser keeps a local copy within the published limits; it does not sync to your account. Clearing site data or browser cleanup can delete it. Download important ideas.

    Does Pause turn the microphone off?

    No. It stops adding audio to the take but keeps the input active so you can resume. Finish releases the microphone. If you only activated it to check the level, use Turn microphone off.