PRACTICAL GUIDE

Effects chain order: EQ, compressor, saturation and reverb

Why each effect usually goes where it goes — common mixing criteria, not a fixed rule.

On this page5 sections

Order changes the signal each effect receives. Choose a route for the result you want and compare at similar volume. If level and dynamics are still unclear, start with mixing fundamentals.

EQ before or after the compressor — depends on what you're fixing

Before a compressor, EQ changes both audible tone and the signal reaching its detector. Removing energy that triggers unwanted reduction may help, but also changes the sound. If the plugin offers a sidechain filter, you can change detection without applying that same EQ to the audible signal.

After a compressor, EQ shapes its output tone; a boost may also raise peaks. Compare both routes at similar levels and listen to envelope changes. Neither position is always corrective or always creative.

Saturation before or after: what changes

After compression, saturation may receive a steadier level. Before it, saturation can change the harmonics and peaks the compressor encounters. Results depend on saturation type, input level and applied reduction.

Try both orders at similar volume and keep the one that serves the sound. Saturation is optional if the track already does its job.

Reverb and delay: inserts and sends

As inserts, order determines what is processed afterwards: compression after reverb can change its tail, and EQ after it can remove bass. These routes can be deliberate choices.

With a send to an auxiliary track, dry and processed signals follow separate paths. You can share a reverb, filter its return or compress it with a control signal. Check level, dry/wet balance and what reaches the final bus. The delay calculator provides BPM-related durations; choosing a note value remains a musical decision.

A reference starting point, not a law

One experiment is EQ → compression → saturation, with reverb on a send. It is not a mandatory chain or an automatic HertzKit process. Duplicate the version, change only one order and compare the same passage at matched loudness.

Check gain between stages and measure the output too. Evaluate the change with the A/B comparator. For routing and sends, see the Ableton mixing manual; the concept also exists in other DAWs, whose controls may differ.