1. Calculate which frequencies to investigate
Measure the length, width and height between the finished surfaces. Start with a rectangular room of 5 × 4 × 2.5 m at 20 °C. Open the calculator, select metres and filter to axial modes. The indices show which dimension is involved.
- Length (1, 0, 0). 34.34 Hz.
- Width (0, 1, 0). 42.93 Hz.
- Height (0, 0, 1). 68.68 Hz. The second length mode, (2, 0, 0), occurs at the same frequency.
Mark those frequency ranges for measurement. The overlap at 68.68 Hz does not tell you how loud that bass note will be. The positions of your speakers and microphone affect what you measure. These frequencies are estimates for an ideal rectangular room.
2. Save a baseline measurement
Use a measurement microphone, its calibration file if available, and software that records an impulse response, such as Room EQ Wizard. Set the microphone on a stand at ear height. Start at a moderate level and check that neither the input nor the output clips.
- Measure each speaker separately at your usual listening position. Save both traces with the channel and position in the filename.
- Repeat a few centimetres forward and backward. Record the distance and keep the playback level, microphone orientation and sweep settings the same.
- Compare frequency response and decay. Use the same scale and smoothing in each view.
If you do not have a suitable microphone, start by listening to familiar music. Use measurements for conclusions about levels in dB and decay.
3. Tell a peak, a dip and a long decay apart
- Peak with a long decay around 69 Hz. If the decay plot confirms that this range rings out, try a placement change and consider bass treatment if it persists.
- Dip that shifts when the microphone moves. Review the seat and speaker positions. Avoid a large EQ boost until you understand the cause.
- Different results by channel. Compare left and right separately. Check symmetry and the distance to nearby surfaces.
These are examples of how to interpret a measurement. The calculator provides the predicted frequencies. Your measurements reveal the peaks, dips and decay.
4. Change one thing and measure again
Start with placement. Mark the original position with tape, then move the chair or move both monitors as a pair. If you move the chair, record a specific change, such as 15 cm forward. Measure again at the same level and compare it with the baseline.
Keep the change if it improves the problem range without creating a substantial dip elsewhere or upsetting the channel balance. Check nearby positions and listen to familiar music. If you try treatment, select materials based on absorption in the relevant band and repeat the same process. A thin panel’s effect on high frequencies tells you little about its performance near 69 Hz.
5. Use band-by-band RT60 with care
At 500 Hz in the example room, using illustrative absorption coefficients of 0.15 for walls, 0.25 for the floor and 0.12 for the ceiling, the tool estimates 0.57 s with Sabine and 0.52 s with Eyring. Enter those values in the 500 Hz row. The models differ in how they account for absorption.
Both assume a diffuse field. Individual resonances often dominate low frequencies in a small room. Around 69 Hz, use a spectral decay or waterfall plot to see how long that range rings. For band estimates, use coefficients appropriate to the material and how it is mounted. The sample coefficients are for practice.
6. Keep a record you can reproduce
Record the dimensions, channel, microphone position, level, placement change and the frequencies that improved or worsened. Save the measurements in your measurement software and log the changes in a HertzKit practice project if you want to revisit them later. To access your notes from another device, sign in and save the project to your account.