HERTZKIT / AUDIO PRACTICE
EQ with purpose: listen before adjusting
Identify what you want to change with EQ and compare the result at equal loudness.
On this page8 sections
Hear the excess and the cost of removing it
Three versions of the same piano, guitar and double-bass accompaniment. The excess in the first was created for this exercise; it is not a diagnosis of your mix.
Choose a version to play.
Save prepared fileFirst listen: compare A and B while following the low notes. Do they take up too much space in A? Then compare B and C: what body does the guitar lose when so much low-frequency content is removed? The three versions have approximately matched integrated loudness.
Apply it: if B feels clearer, that describes this material. In your mix, first name the instrument or phrase that is hard to hear. Make one change and also check a passage where that instrument is exposed. Keep an unprocessed copy.
Example settings
A has a 6 dB boost centred at 260 Hz, Q 0.8. B applies a 6 dB cut at the same frequency and Q to A. C applies a two-pole high-pass at 450 Hz to A. Playback levels were compensated between versions. These settings make the exercise audible; they are not presets for voices, guitars or mixes.
HertzKit material under CC0. Provenance, settings and permission · TXT
First, describe the problem
“It sounds bad” does not tell you what to change. Try something specific: the vocal loses clarity when the guitar enters, the bass masks the kick, or a consonant sounds sharp. Listen in context, then solo the track to investigate. EQ changes frequency balance; it does not separate instruments from a mix or recover information missing from a recording.
Small changes, clear questions
Start with a moderate adjustment and listen again. A broad cut may reduce a general excess; a narrow one may address a specific resonance. There is no universal frequency that removes “nasal” or “muddy” sound: it depends on the note, voice, instrument and room. A high-pass filter can also remove body; move it while listening rather than following a chart.
Compare without the volume trap
Export an original version and an adjusted version from the same start. Compare at matched loudness and ask whether the problem improved without creating another one. An analyzer helps locate energy, but a curve cannot decide what sounds musical. If a simple take needs ten corrections, revisit the source and microphone placement. Keep an unprocessed version so you can go back.
Try a vocal and guitar passage
Choose ten to twenty seconds where the problem occurs. For example: the solo voice is clear, but words disappear when the guitar enters. Keep an unchanged version A. In your editor or music software, make a version B with one adjustment to the guitar; do not also change the voice, bass and overall level.
- Listen to the full phrase with every instrument playing. Identify the word that becomes hard to understand.
- Try a moderate cut where the guitar competes with the voice. Do not copy a fixed frequency: move the adjustment and listen for the word becoming clearer.
- Export A and B from the same start with the same duration. Match their loudness in HertzKit’s comparator and switch over that passage.
- Listen to a passage where the guitar is more exposed too. If it lost the character you needed, reduce or discard the cut.
When is the change worth keeping?
Keep B if it addresses your named difficulty and still works elsewhere in the song. If the word only becomes clear after a large vocal level increase, consider the arrangement, phrase automation or another take. Record a reason: “the last word is clear without thinning the guitar” is more useful than “B sounds better.” Try it with your own versions: HertzKit’s comparator lets you listen to them, but does not apply EQ.
Put the idea into practice
Reference for further reading
You can continue with hear compression or check the mono sum.